DSI 2 Front Panel Connector (SV40) w-Banana Jack Controls and connected to the HD19

and connected to the HD19 connector on a DSI 2 Die Protection Sensor Interface using an HD19 cable (available separately)

Up to 8 die-mounted sensors can be wired to the 12-pin terminal block on the back of the board

The Material Buckle Sensor is compatible with the Wintriss DSI 2 DiPro Sensor Interface and can be used in conjunction with the Wintriss SmartPAC PRO DiProPAC Die Protection Module and DiPro 1500 controllers

This 19-pin connector is compatible with the HD-19 cable/HD-19 kit

Amperage Range:    0 to 200 A AC   Minimum Setpoint:   1

DSI 2 Front Panel Connector (SV40) w-Banana Jack Controls and connected to the HD19This connector plugs into the front panel of an 8 intput DSI 2 and enables you to wire most single wire electromenchanical sensors to the DSI 2.